This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 55 (click to view)
In case of difficulty
Sound is harsh or high frequencies are not reproduced. Sound is distorted. ÷ The head is dirty. ÷ The tape is stretched or shrunk. ÷ The tape being played was recorded with distorted sound. ÷ A tape which has been recorded with the equalizer and/or 3D surround effects is being played back by applying the equalizer effect. ÷ The tape head is magnetized. ÷ External noise is induced. ÷ A tape which has been recorded with Dolby NR is being played back without switching the Tape Equalizer. Sound vibrates. ÷ The capstans or pinch rollers are dirty. ÷ The tape is wound irregularly.
55
÷ Clean the head referring to �Maintenance�. ÷ Try another tape. W ÷ Try another tape. ÷ Switch off the equalizer and 3D surround effects before starting playback.
y
Noise is noticeable.
÷ Demagnetize the head referring to �Maintenance�. W ÷ Install the system at a distance from other electric appliances and TV. ÷ Switch on the Tape Equalizer.
£
÷ Clean the head referring to �Maintenance�. W ÷ Wind the tape again by fast forwarding, rewinding or playing from an end to the other. £ ÷ Use a cassette with an unbroken recording protect tab or block the hole. 5 ÷ Close the holder completely.
Recording cannot be started by pressing the record key.
÷ The recording protect tab of the cassette has been broken. ÷ The cassette holder is not closed completely. ÷ The TAPE input is selected. ÷ The tape is fully wound to one of the reels.
�
÷ Select the source to be recorded with the CD, TUNER, or AUX key. ª ÷ Change the tape transport direction of deck B or reverse the tape insertion orientation. �
CD player
Symptom
A CD is placed in the player but it cannot be played.
Cause
÷ The disc is placed upside down. ÷ The disc position is displaced. ÷ The disc is extremely dirty. ÷ The disc is scratched. ÷ Dew is condensed on the optics lens.
Remedy
÷ Place the disc properly, with the label side facing upward. ÷ Place the disc properly. ÷ Clean the disc referring to �Handling of discs and tapes�. ÷ Try another disc. ÷ Refer to �Caution on condensation� and remove the condensation by evaporation.
Knowledge section
) ) 5 W
Sound is not produced.
÷ The disc has not been placed. ÷ The player is not set to the play mode. ÷ The disc is extremely dirty. ÷ The disc is scratched.
÷ Place a disc in the CD player. ) ÷ Press the play key. ) ÷ Clean the disc referring to �Handling of discs and tapes�. 5 ÷ Try another disc. ÷ Clean the disc referring to �Handling of discs and tapes�. 5 ÷ Try another disc. ÷ Install the unit in a place not subject to vibrations.
Sound skips.
÷ The disc is dirty. ÷ The disc is scratched. ÷ The player was subjected to vibration.
