|
|
|
Who's Online
There currently are 5923 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good product. Best service manual. Many thanks
;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
X92-4400-0x/4730-0x X92-4740-0x/4750-0x DISASSEMBLY AND ASSEMBLY OF MECHANISM
â� Disassembly for loading cam (30) drive arm (19), lock slider (23), and rear lock arm (24)
1) The screw (D) and the loading cam (30) are removed. Note: The screw for loading cam (D) is not reusable. Please be sure to exchange. 2) The spring (58) for trigger sliders is removed. 3) The stopper (49) is removed. 4) The spring (64) of the rear lock arm (24) is removed. 5) The screw (B) and washer (K) of the drive arm (19) are removed, and the drive arm (19) is moved back to rear side. The drive arm (19) is removed. 6) Lock arm (25 and 26), lock slider (23), rear lock arm (24) and each gear is removed.
LOADING CAM (30) 35 16 15 32 33 34 26 25 B 49 24 64 BK 19 23 65
58
D 1
â� Assembly for the loading cam (30) drive arm (19), lock slider (23), and rear lock arm (24)
1) The trigger slider (15) is fixed in the main chassis (1), and is moved back to rear side. 2) The loading slider (16) is fixed to the trigger slider (15). Note: At this time, it is cautious of the position of the hook of the loading slider (16). 3) The gear (4 pcs) is fixed in main chassis (1). 4) The lock arm (25 and 26) and the rear lock arm (24) are fixed. 5) The spring (65) is covered over the lock slider (23). The spring (65) is assembled with through for a main chassis (1) hole. It takes care that the spring (65) does not run aground to the lock slider (23). 6) The loading slider (16) is moved back to the rear side. The lock arm (25 and 26) moving to OPEN position, and the drive arm (19) is fixed (Put in seven places boss).
23 16 65
7) The loading slider (16) is fixed on the washer (K) and the screw (B). (Torque 3±10% kgf.cm) 8) The lock arm (25 and 26) is closed by hand and the lock slider (23) is moved for close position, and the stopper (49) is fixed on the screw (B). (Torque 3±10% kgf.cm) 9) The loading cam (30) is fixed on the screw (D). (Torque 1.5±10% kgf.cm) 10) The spring (58) is fixed to the trigger slider (15) and the loading slider (16). 11) The spring (64) is fixed to the rear lock arm (24).
64
B K 19
24
15 58 1 D
30
17
|
|
|
> |
|
