|
Who's Online
There currently are 509 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
 |
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
 ;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
 ;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
 ;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
TK-3168
DISASSEMBLY FOR REPAIR
1. Separating the case assembly from the chassis.
1. Remove the volume knob z. 2. Remove the two screws x. 3. Lift the chassis c, and remove it from the case assembly. Note: After separating the case assembly from the chassis, remove the channel knob.
3. How to remove the battery terminal block.
1. Remove the two screws /, then pull out the back cover Ω. 2. Remove the screw ≈.
2. Separating the chassis from the TX/RX unit.
1. Remove the two screws v fixing the TX/RX unit B/2. 2. Remove the twelve screws b and two screws n fixing the TX/RX unit A/2. 3. Remove the solder from the antenna terminal using a soldering iron m, then lift the unit off.
Note: The two screws n of TX/RX unit A/2 are fixing the battery terminal block ,.
4
|
|
 |
> |
|