|
Who's Online
There currently are 5800 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
RXD-951/A700/A900/V616/V818/V919
DISASSEMBLY FOR REPAIR
1. How to remove the front panel.
(1) Turn the power ON and then push the open/close key to open the tray. (2) After removed the tray cover, push the open/close key to close the tray and then turn the power OFF. (3) Remove the push rivet (1) and 4 screws (2, 3). (4) The front panel can be separated by removing the 3 screws (4) located at the bottom plate of the front panel.
6 x2 6 7 6 3 3 3 2 1
2. How to remove the CD mechanism
(1) Remove 4 screws (5) on the left side/right side of chassis. (2) Remove 4 screws (6) and the cap (7) on the rear panel. (3) Disengage the CD mechanism as FIG.2. (4) Connect the GND plate of X32 PCB and the chassis with a alligator clip wire (8).
5 x4 4 x3
Fig.1
3. How to remove the mult control knob.
� Remove the knob by string (9).
4. How to open the tray if not comes out.
(1) From the rear side of the CD mechanism, use a screw driver or the like to turn the friction arm fully counterclockwise. (2) Pull out the tray front wards by hand when the tray comes just out. * As for details of items in the below, refer to RXD-F3 service manual (B51-5091-00). (1) How to detach the tray. (2) How to attach the tray. (3) Replacing the pickup.
8
REAR SIDE Friction Arm
9
Fig.2
4
|
|
|
> |
|