|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
General features
English
Removing the Faceplate
The faceplate can be detached from the unit, helping to deter theft. Removing the faceplate: � When removing the faceplate, pull it out only when it is fully open. The detachment of the faceplate while it is moving might result in damage to the unit. � Do not apply excessive force to the faceplate bracket without attaching the faceplate. Doing so will cause the faceplate bracket to be deformed. � Do not touch the connector on the faceplate bracket after removing the faceplate. Touching the connector may cause damage to the unit. � Do not touch two metal parts on both sides of the faceplate bracket. Touching those parts may injure you.
NOTE
1 Choose the way from among the following and open the
faceplate. Turn the ignition off, press the SRC button for at least one second, or press the left part at the upper side of the faceplate (as illustrated on p.11) for as many times as you have preset in the "Manual Open Button Setting" (OPEN SW #) in the menu when the control panel has been hidden. 2 Set the faceplate's angle adjustment switch to "0" to set the faceplate angle to the vertical. For details, refer to "Faceplate Angle Adjustment" (page 13).
NOTE
If the faceplate's angle adjustment switch is not set to "0" when mounting the faceplate on the faceplate bracket, it may be difficult to mount the faceplate or the faceplate may not be securely attached and could fall off. Set the angle adjustment switch to "0" before removing the faceplate.
� Sliding the faceplate lock switch cause the unit�s power to turn off. If you want to operate the unit again, remove the faceplate from the faceplate bracket completely and then reattach it. � The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. � Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. Reattaching the Faceplate:
1 Hold the faceplate so that the control panel faces the front
toward you and set the left side of the faceplate in the faceplate bracket.
2CAUTION
3 Slide the faceplate lock switch to the left during the period
which you have set in the "Time setting for removing the faceplate" in the menu.
Do not set the right side of the faceplate in the faceplate bracket first, when reattaching the faceplate. Doing so may cause the connector on the faceplate bracket to malfunction. 2 Press the right side of the faceplate until it locks.
Faceplate lock switch
4 Holding the center part of the faceplate, pull it out.
The faceplate bracket will automatically close.
2CAUTION NOTE
If the faceplate bracket's angle was not set to the vertical when
� 12 �
|
|
|
> |
|
