perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Text excerpt from page 29 (click to view)
s Removing the hard rubber frame 1 Engage the catch pins on the removal tool and remove the two
locks on the lower level. Lower the frame and pull it forward as shown in the figure.
Catch Lock
s Removing the Unit 1 Refer to the section �Removing the hard rubber frame� and
then remove the hard rubber frame. 2 Remove the Hex-head screw with integral washer (M4�8) on the back panel. 3 Insert the two removal tools deeply into the slots on each side, as shown.
Accessory3 Catch facing up
Accessory2 Removal tool
2 When the lower level is removed, remove the upper two locations.
4 Lower the removal tool
toward the bottom, and pull out the unit halfway whilst pressing towards the inside.
2CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
NOTE
The frame can be removed from the top side in the same manner.