|
|
|
Who's Online
There currently are 5980 guests and
2 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
 ;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
;
manual excelente completo , diagramas y esquemas bien presentados y buena calidad de imagen.
KRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RG KRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG
ADJUSTMENT
No ITEM INPUT SETTINGS RECEIVER SETTINGS ALIGNMENT POINTS ALIGN FOR
FM SECTION
1
SD
98.1MHz 0 dev 35dBµ(ANT input)
TEST MODE: ON FM 98.1MHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
AM SECTION
(1)
SD
990 kHz 0% mod 35dBµ(ANT input)
TEST MODE: ON AM 990 kHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
CASSETTE DECK SECTION
[1]
HEAD HEIGHT
SCC-1659
TAPE PLAY
Head Height Screw
1) During FWD transport adjust F and F ' so that line A of 2LINE TAPE passes through the center of the head shield plate (core center area) 2) During RVS transport adjust R and R ' so that line B of 2LINE TAPE passes through the center of the head shield plate (core center area) 3) After the alignment above, reverse the transport direction and check the FWD alignment again. If it is deviated, perform alignment again. (Tape used : SCC-1659,manufactured by A-BEX)
[2]
HEAD AZIMUTH
TCC-153 10kHz
Connect an AC voltmeter and oscilloscope to SP outputs. TAPE PLAY
Head Azimuth Screw
Adjust the azimuth for each L ch/R ch or FWD/RVS becomes maximum.
TEST MODE : ON TEST MODE : OFF
While holding the "FM" key and preset "6" key, reset the unit. Reset the unit.
TAPE SPEED
(2-LINE TAPE)
B
HEIGHT (FWD)
F
'
R
'
A (FWD)
HEIGHT (RVS)
B
HEIGHT/AZIMUTH (FWD)
F R
HEIGHT/AZIMUTH (RVS)
A
(RVS)
5
|
|
|
> |
|
