|
Who's Online
There currently are 5714 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
ecelent I was reciver the service manual soon I fell so happy very complete 100% positive all by this store tanks atte Luis salazar
;
A great copy of the manual, and the only one I could find anywhere on the net! The circuit diagrams are easily readable, all component values marked and easy to see. A highly appreciated download!
;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
KDC-C471FM/C521FM
ADJUSTMENT
� L.P.S. initial position adjustment procedure
1. Connect the changer to the HEAD UNIT (H/U). 2. While holding the magazine eject button of the changer, press the reset button of the H/U. 3. After about 3 seconds, release the magazine eject button. 4. Press the SRC button of the H/U to enter the CD-CH mode, and the H/U's display section indicates �E-88�. 5. Move the mechanism deck to around the 1st stage by pressing the DISC- or DISC+ button. 6. Insert the adjustment tool (W05-0635-00) into the tool hole on the changer mechanism. 7. Then press the DISC+ button to move the mechanism deck until the mechanism's slider hits the adjustment tool. 8. When the motor locks (stops), press the REPEAT key of the H/U. When the REPEAT key is pressed, the mechanism moves automatically to the 1st stage and the initial position adjustment completes. (The data is written in the EEPROM at this time.)
W05-0635-00
� Caution : Note on IC8 (EEPROM)
Be sure to use the W05-0869-00 when replacing the EEPROM. IC8 stores the digital servo data of the pickup servo. Therefore, if the EEPROM does not store servo data, ERROR76 (E-76) will indicate the H/U�s display section at the moment CD is played.
Instrument : SSG, OSC (5MHz), AC VOLTMETER, PWR SUPPLY, H/UNIT, CD-CH
RECEIVER (MODULATOR) FREQ ALIGNMENT POINTS
No.
ITEM
INPUT SETTINGS
OUTPUT SETTINGS
ALIGN FOR
FIG.
Connect a 1 L/R Balance Adj. CD-CH cignal off (Tr No.29 or Pause) Oscilloscope to Q301 Base. Difference between Moduration 2 level Adj. 1. Ref.FM 1kHz 80dBµV Stereo, CD-CH Tr No.1 2. D.Cont Off MOD Lv:2 Connect a AC voltmeter to Receiver PreOut 88.3MHz VR302 FM and a CD-CH level is adjusted to (-0.5±1.0dB). * After Adj. The glue is applied to VR301, VR302. 88.3MHz VR301 Min Level (a)
(Scope Setting Condition for L/R BAL. Adj.) 1. VOLTAGE RANGE : 5mV 2. TIME/DIV : 50µs
Adjusted to be min level point
(Before Adj.) Fig. (a)
(After Adj.)
9
|
|
|
> |
|