- CIRCUIT DESCRIPTION
- PC BOARD
- SCHEMATIC DIAGRAM
- EXPLODED VIEW
- PARTS LIST
There are currently no product reviews.
This was super service.Ordered this manual and was reading the download an hour later
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
Wow very wonderful and clear!!!! I will always trust them
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
SOURCE DIRECT CD PHONO TUNER TAPE MD
MIN ON OFF MAX
INPUT SELECTOR A SPEAKER B BASS TREBLE BALANCE MUTING LOUDNESS
thermally reactive advanced instantaneous transistor
T RA I T
1 POWER switch (KAF-3010R)
Usually leave this switch to the on position. When the unit is not to be used for a long period of time, set the switch to the OFF position for safety.
9 SOURCE DIRECT indicator
Usually leave this switch to the on (standby) position.
0 SOURCE DIRECT key
To listen to a source with high quality sound.
2 ON/STANDBY key (KAF-3010R)
This key effective when the POWER key is set to the on (standby) position, and pressing this key turns power ON and off (standby).
! PHONES jack
Used for headphone listening.
@ SPEAKERS A/B switches
Press to select the A and/or B speaker systems.
3 Standby indicator (KAF-3010R) 4 POWER switch (KAF-1010) 5 BASS knob
To adjust low frequencies.
# BALANCE knob
$ INPUT SELECTOR knob % MUTING key/indicator
Mute the sound temporarily.
Adjust the volume balance between left and right. Turn to select the input sources.
6 TREBLE knob
To adjust high frequencies.
7 INPUT indicator
An indicator lights for the source selected with the INPUT SELECTOR knob.
^ LOUDNESS key/indicator
Use to emphasize deep bass sounds.
& Remote sensor(KAF-3010 ONLY)
8 VOLUME CONTROL knob
Adjust the volume.
About the standby indicator (KAF-3010R only)
This unit has a standby indicator that lights to show that a small amount of current is being supplied to the unit in order to preserve the memory. This is called the Standby mode. When the Standby indicator is lit, the amplifier can be switched ON / STANDBY from the remote control.