5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
very helpful, the information in these manuels are very detailed
Text excerpt from page 14 (click to view)
Programmed play (PGM mode)
Use the following procedure to program desired tracks in a desired order. (up to 20 tracks)
14
Preparation
÷ Load a disc in the CD player.
@
The figure shows an example for the DPF-2030
0
7
4 1
6
¢ ¡
: Keys and control used in the operations described on this page.
1 Press so that the �PGM� indicator lights.
Do this operation in the stop mode.
P.MODE
0
Lights up.
TRACK PGM NO.
Go to step 2 within 5 seconds.
01
2 Program desired tracks.
1 Select the desired track No.
Main unit
(Except for DPF-2030)
Remote control unit
(Except for DPF-1030)
Displays the entered program No. for a few seconds.
Displays the total playing time of the programmed tracks.
(Programming is not possible during playback)
Press the numeric keys as shown below.... To enter track No. 15: 05
1 2 3 4 5 6
TRACK NO.
TRACK NO.
TOTAL
TIME
4
¢
02
P_ 01
02
_1 6 : 4 2
7
8
9
0
+10
Go to step 2 within 5 seconds.
2 Set the entry.
P.MODE
0
3 Repeat steps 1 and 2 above.
÷ Up to 20 tracks can be programmed. When �FULL� is displayed, no more tracks can be programmed. ÷ If you make a mistake, press the CLEAR key and enter the track No. from the beginning. ÷ When the total playing time of the programmed tracks exceeds 100 minutes, the remaining time on the disc will not be displayed any more.
3 Start playback.
0
6
÷ When the 4 or ¢ key is pressed during playback, the track will be skipped in the direction of the pressed button. ÷ When the 4 key is pressed once during playback, the play position returns to the beginning of the current track being played.