There are currently no product reviews.
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
Very good service for get any documentation. Fast and perfect quality.
Excellent service manual with all the necessary info. :)
The product dowload was delivered efficiently with emails to support its download availabilty. The contets of the manual was very eligible and of good quality. Will purchase from this site again!
No. ITEM INPUT SETTINGS OUTPUT SETTINGS CASSETTE DECK SETTINGS ALIGNMENT POINT ALIGN FOR 0 dBs = 0.775 V Demagnetize the REC/PLAY head with a head demagnetizer. Clean the REC/PLAY head, erase head, capstan and pinch roller using a cotton swab slightly damped with alcohol. Maximum output. (a) (b) FLG. CASSETTE DECK SECTION I. REC/PLAY HEAD  DEMAGNETIZATION â â POWER OFF Remove the cassette door. REC/PLAY head REC/PLAY head, erase head, capstan pinch roller Azimuth adjustment screw TAPE: NORMAL, DOLBY: OFF, INPUT: LINE IN
(A) MTTÂ·114, TCC-153 0 kHz, -10 dB
II. DC BOARD  TAPE SPEED (A) MTT-111, TCC-110 3 kHz (B) PLAY SFR301 Adjust the tape speed so that a 3 kHz signal is produced at the center of the tape.
III. PC BOARD <1> <2> PLAYBACK LEVEL RECORD LEVEL MTT-150 400 Hz (200 nWb) (A) 1 kHz, -20 dBs (A) 1 kHz, -20 dBs 10 kHz, -20 dBs (B) PLAY Record 1kHz and 10kHz in alternation and playback. DECK B SFR101 (L) SFR102 (R) SFR107 (L) SFR108 (R) Output level : Â±1 dBs 0 dBs Â± 3 dBs Record 1 kHz and 10 kHz in alternation and adjust the variable resistors which control the bias current so that the playback level is obtained 0 dBs Â± 3 dBs. 105 kHz Â± 3 kHz (c)
Record and playback at maximum REC volume position.
SFR105 (L) SFR106 (R)
REC BIAS OSC FREQUENCY
(a) AZIMUTH ADJUSTMENT
LINE IN LINE OUT
AC voltmeter Frequency counter
(b) AZIMUTH ADJUSTMENT
To Frequency counter